Paint Shop Pro support - Question about editing selections

Author

Question about editing selections

Nathan Gutman

2004-09-22, 7:23 pm

Using PSP9. When I edit a selection and paint or erase the mask it
appears OK while in the selection editing mode. When I switch off that
mode the selection marquee shows some residuals which are not seen in
the Edit Selection mode so I have keep going back and forth till it's
done.
Can anything be done on that so the final selection marquee reflects
correctly what what was seen in the Editing mode?
Thanks, Nathan

Trev

2004-09-22, 7:23 pm

"Nathan Gutman" <ngutman@earthlink.net> wrote in message
news:q4f3l0hjvcrqok3nv8i573ilgvg4tu3m85@4ax.com...
> Using PSP9. When I edit a selection and paint or erase the mask it
> appears OK while in the selection editing mode. When I switch off that
> mode the selection marquee shows some residuals which are not seen in
> the Edit Selection mode so I have keep going back and forth till it's
> done.
> Can anything be done on that so the final selection marquee reflects
> correctly what what was seen in the Editing mode?
> Thanks, Nathan

As painting with black adds and white removes which is what I hope you meant
by erase Then you must be missing bits. Zoom in well and dont use to soft a
brush unless your trying to create soft fathered edges in which case you my
not have be leaving gaps by your chose of grey or brush density

fugitive

2004-09-22, 7:23 pm

On Wed, 22 Sep 2004 18:01:51 GMT, Nathan Gutman
<ngutman@earthlink.net> wrote:

>Using PSP9. When I edit a selection and paint or erase the mask it
>appears OK while in the selection editing mode. When I switch off that
>mode the selection marquee shows some residuals which are not seen in
>the Edit Selection mode so I have keep going back and forth till it's
>done.
>Can anything be done on that so the final selection marquee reflects
>correctly what what was seen in the Editing mode?
>Thanks, Nathan

In selectons there is a remove holes and specks mode, it's off of the
modity button.