| Author |
Can't see or get Guide lines in PSCS2?
|
|
| Trial Run 2005-10-28, 6:16 pm |
| I have View/Rulers on, I can see in the top left corner on the ruler,
the little lines that I should be able to drag out my guides lines
with.
I click on them and hold my mouse button and then release it when it is
where I want the guide line, but nothing stays there. I can see the
line moving with my house across the image.
The color is default blue, are there any other settings that I need to
adjust, such as the size??
I was following a tut Chapter 9 in CIBCS2.
http://www.adobe.com/education/pdf/...scs2_cib_09.pdf
Page 5.
I am only one week into PSCS2 and so far this is the only thing I have
not been able to get to work!!
Any suggestions?
| |
| Trial Run 2005-10-28, 6:16 pm |
| Geezz got it!! Drag from the numbers area, not the upper most left
corner of the rulers!! Cursor turns into a little two way black arrow
thingy!!
This is just for us newbies...the rest of you continue on!! ;o)
| |
|
| In article <1130527984.549828.9960@g43g2000cwa.googlegroups.com>, legacy64
@hotmail.com says...
>
>Geezz got it!! Drag from the numbers area, not the upper most left
>corner of the rulers!! Cursor turns into a little two way black arrow
>thingy!!
>This is just for us newbies...the rest of you continue on!! ;o)
Glad you got it. That little "box" in the upper left allows you to zero your
rulers for some point, other than the upper left corner.
Hunt
| |
| Trial Run 2005-10-29, 6:14 pm |
| Aaahhhh that's why my ruler numbers where moving the "0" halfway across
my page!!
I couldn't figure out why it was doing that either, but now I do!!
Thanks so much!!
|
|
|
|
| Copyright 2003 - 2008 forum4designers.com Software forum Computer Hardware reviews |